Ididit Right Hand Drive & Collapsible Steering Column Bedienungsanleitung

Installation Instructionsfor Tri-Five ChevroletsSteering Column to Steering BoxRight Hand Drive Steering ColumnInstruction # 8000000001 REV 12/12www

9Once you have the box mounted in position, a rag joint is used to connect it to your new column. This is a direct hook-up. The tilt column uses

steerIng wheel modIfIcatIons for 1955-56-57 chevys wIth stock steerIng wheel mounted on steerIng columnThe spline in your stock steering wheel is

11After market steering wheel with the short adaptor on the new column with shift and tiltAfter market steering wheel with the short adaptor on the ne

Accessories Important to Installation: #2401400010 Classic Chevy Floor Mount This oor mount bolts through the oor in the original holes. It st

Notes:13

www.ididitinc.com14

ididit, inc.610 S. Maumee St., Tecumseh, MI 49286(517) 424-0577 • (517) 424-7293 faxwww.ididitinc.comNo part of this guide may be reprinted, reproduce

1Thank you for purchasing the Tri-Five Chevy column from ididit.This is a simple overview of how to mount your column. Any steering column must be sec

2The Classic Chevy Floor Mount is made up of two pieces:A.) T-shaped L BracketB.) ClampThe T shaped bracket mounts in the original bolt holes in the

3Turn Signal Lever:The turn signal lever is located closest to the top of the column. With the steering wheel and adaptor removed, look down at the to

4Wiring your ColumnThis ididit steering column uses a standard 3 7/8-inch male connect. How-ever, some GM columns use a 4 ¼-inch male connecto

1. The front wheels must be pointing straight forward with steering toe set reasonably close.2. Rotate the steering box input shaft from lock to lock

Cut approximately 6” up from the box and work your way down until the column is properly positioned in your dash. (See “Synchronizing Your Column”

7InstallatIon InstructIons for the classIc 1955-56-57 chevy – tIlt steerIng wIth column shIfter, usIng stock gear BoxThe other end of the coupler wil

Once you have the box mounted in position, a rag joint is used to connect it to your new column. This is a direct hook-up. This column uses a